Need service? Call:972-681-2222 

Programming Multi-Button Remotes with Internal Set Switches

Caution! Before activating the door, be sure that all people, pets, ladders, vehicles and other obstructions are cleared from the door’s path.

These garage door opener transmitters have 2 smaller switches to the right of the internal Code Setting Switches. The small right switch should be set according to how many Code Setting Switches in your receiver (either 9 or 12). The small left switch is for programming purposes. To program a button for one of your doors, follow the instructions below:

  1. First, match the settings on the Internal Code Setting Switches with the same set of switches in the receiver on the garage ceiling, as described in the previous programming instructions.
  2. Next, move the small programming switch to 'S' (for SET) and press the transmitter button you wish to have assigned to the above door.
  3. Last, return the programming switch to 'R' (for RUN) and press the assigned transmitter button to test the door and start the door moving. Follow the same procedure for each additional door you wish to program.

Still Having Trouble Programming Your Remotes?

We Will Come To Your House and Program it For You!


These are general instructions on how to program your remotes if they do not work for you please feel free to give us a call and one of our friendly reps will walk you through it at no charge please just have your Manufacturer and Model numbers available. In most cases we will be able to help you over the phone if not we can send one of our technicians out to your house and program it for you at a small fee.



Toll Free 24/7

Dallas County
972 - 681 - 2222
North Dallas
972 - 335 - 5885
Tarrant County
817 - 496 - 3000

accepted cards


 Visit our facebook page here!

Copyright 2011 American Service Center - Dallas/Fort Worth's premier source for garage door installation and repair! Design by Matt Lozoya. Increase your website traffic with